Maric | Wafer Type Flow Control Valves | PVC Get latest price

Features:

• Materials: Body- Grey UPVC, Special grade to suit potable water requirements to AS4020.
  Sealing O’Rings - Nitrile, potable water approved to AS4020 or EPDM or Viton if applicable
• Flange Specification: Suits standard table “D” flanges to AS2129 and AS4087 Class 14
  Alternative specs are available - Refer to Valve Selection Guide for additional info. Standard Wafers are not full flange type i.e. flange bolts locate wafer concentrically and remain visible when viewing assembly. Wafers are fitted with an o’ring in each face for sealing against smooth flat faced flanges. Gaskets will however be required where grooved, raised or rough cast face flanges are used. PVC and Poly Stub Flanges note; Due to smaller I.D. of these flanges/pipes, optional spacers are often required to prevent restriction
• Max Pressure Differential: 1000 kPa or limited by Control Rubber type
  Max Hydrostatic Pressure: 3000 kPa
• Max Temperature: 50C
• Compatible Control Rubbers: Standard Precision P (Non Standard LP, EP, K, V, HF)

To contact Maric Flow Control Australia about Maric | Wafer Type Flow Control Valves | PVC use Get a quote.

Features:

• Materials: Body- Grey UPVC, Special grade to suit potable water requirements to AS4020.
  Sealing O’Rings - Nitrile, potable water approved to AS4020 or EPDM or Viton if applicable
• Flange Specification: Suits standard table “D” flanges to AS2129 and AS4087 Class 14
  Alternative specs are available - Refer to Valve Selection Guide for additional info. Standard Wafers are not full flange type i.e. flange bolts locate wafer concentrically and remain visible when viewing assembly. Wafers are fitted with an o’ring in each face for sealing against smooth flat faced flanges. Gaskets will however be required where grooved, raised or rough cast face flanges are used. PVC and Poly Stub Flanges note; Due to smaller I.D. of these flanges/pipes, optional spacers are often required to prevent restriction
• Max Pressure Differential: 1000 kPa or limited by Control Rubber type
  Max Hydrostatic Pressure: 3000 kPa
• Max Temperature: 50C
• Compatible Control Rubbers: Standard Precision P (Non Standard LP, EP, K, V, HF)

Read less...

To contact Maric Flow Control Australia about Maric | Wafer Type Flow Control Valves | PVC use Get a quote.