Unimig Engine Driven Welder | MS600

Unimig - Engine Driven Welder | MS600

Supplier: Electroweld

Engine Driven Welder | MS600

The UNIMIG Mine Spec 600 is a powerful Multifunction Diesel Generator/Welder designed for the Mining and Construction Industries.

Receive 1-3 days from order

The MS 600 delivers value for money with high duty cycle performance of 500amps @ 60% duty cycle, 20kVA auxiliary AC power with both 240V and 415V outlets and the latest safety features. Your investment and reliability is guaranteed with Perkins 404D-22T Turbo diesel engine, Stamford generator and Yunda DC welding inverter.

Welding Performance

The advanced technology Yunda DC inverter delivers superior welding performance with easy arc striking, smooth arc characteristics, low spatter and excellent weld appearance. Reliability is assured with all printed circuit boards potted in resin and encapsulated to prevent exposure to harmful environments.

The UNIMIG MS 600 features five process modes and is supplied with digital volt/amp meters.

MMA
MMA Cellulosic
Air Arc Gouging
DC TIG
MIG / Constant Voltage Wire

MMA is optimised for General Purpose and Low Hydrogen MMA electrode welding.

MMA Cellulosic is optimised for Cellulosic MMA electrode welding.

Hot Start and Arc Force can be adjusted whilst welding in either MMA or MMA Cellulosic modes.

Air Arc Gouging is optimised to run up to 8mm carbon rods and Strike and Re Strike performance is enhanced by optimising

waveform design and VRD response time.

DC TIG welding with Lift Arc ignition and gas solenoid valve for optimal control and minimal gas loss. Constant Voltage Wire is

optimised with adjustable inductance for running flux cored wires.

MIG welding with the unique RWS wire feeder, makes it possible to weld Pulse MIG, Double Pulse MIG, Synergic MIG, Manual MIG and MMA from wire feeder.

Mine spec safety features

Emergency engine stop button located at eye level to quickly shut MS600 down in case of emergency.
VRD Voltage Reduction Device lowers the voltage in CC MMA and CC air arc gouging modes to below
12 volts in less than 300 milliseconds.
Output at welding terminals controlled by electronic contactor, that can be switched on or off.
Stainless steel enclosure
Lockable dual pole battery isolation selector for safer maintenance, note: can only be locked in off position.
RCD protection for auxiliary AC power outlets.
Auxiliary AC power with two 240 Volt single phase and one 415Volt IP66 rated outlets
can also be isolated electrically by switching off circuit breakers behind bolted panel.
Weight with fuel/oil/coolant 700Kgs
AC All wiring looms are encased in conduit with rubber boots fitted to avoid mechanical wear and damage.
Optional Drip tray / Roll cage can be supplied that will contain all liquids used in engine.
IP23 case enclosure.

Features of this product

Fuel, oil pressure, engine temperature gauges and hour meter.
43 horespower, liquid-cooled, 4 cylinder Perkins engine, includes automatic engine idler for greater fuel economy and reduced noise
52 litre fuel tank for 8 hours running at maximum RPM.
Sound rating no load 76dBA @ 7 metres, loaded 81dBA @ 7 metres

To contact Electroweld about Unimig Engine Driven Welder | MS600 use Get a quote.