UWT Continuous Level Measurement
In the area of continuous level measurement of bulk solids within silos, process vessels or open bunkers varying conditions need to be considered to ensure the perfect measurement solution is to be found for the application. These conditions include silo and tank geometry, installation position of the sensor, properties of the medium such as flowability, bulk density, conductivity, moisture, dust and adhesion.
The Nivobob series of plumb bob sensors is used for continuous level measurement within bulk storage silos and for interface measurement.
The simple electromechanical measurement principle is a truly reliable all-rounder in most bulk materials.
The sensor weight, made of a suitable material, attached to either a tape or rope is electromechanically lowered from the top into the vessel. Once the sensor weight rests on the material, the winding direction of the motor changes and the sensor weight is rewound to the upper stop position.
For interface measurements, the sensor weight can be adjusted according to the density of the sediment. The distance is electronically measured and together with the programmed silo geometry information the microprocessors convert this distance into a volumetric output signal. The Nivobob generates an analog 4-20 mA signal and a Modbus RTU or Profibus DP interface for the evaluation systems.
As the system is immune to dust, dielectricity, conductivity, humidity and caking, the Nivobob always delivers a reliable level signal.
To contact Sensor Measurement about UWT Continuous Level Measurement use Get a quote.
In the area of continuous level measurement of bulk solids within silos, process vessels or open bunkers varying conditions need to be considered to ensure the perfect measurement solution is to be found for the application. These conditions include silo and tank geometry, installation position of the sensor, properties of the medium such as flowability, bulk density, conductivity, moisture, dust and adhesion.
The Nivobob series of plumb bob sensors is used for continuous level measurement within bulk storage silos and for interface measurement.
The simple electromechanical measurement principle is a truly reliable all-rounder in most bulk materials.
The sensor weight, made of a suitable material, attached to either a tape or rope is electromechanically lowered from the top into the vessel. Once the sensor weight rests on the material, the winding direction of the motor changes and the sensor weight is rewound to the upper stop position.
For interface measurements, the sensor weight can be adjusted according to the density of the sediment. The distance is electronically measured and together with the programmed silo geometry information the microprocessors convert this distance into a volumetric output signal. The Nivobob generates an analog 4-20 mA signal and a Modbus RTU or Profibus DP interface for the evaluation systems.
As the system is immune to dust, dielectricity, conductivity, humidity and caking, the Nivobob always delivers a reliable level signal.
To contact Sensor Measurement about UWT Continuous Level Measurement use Get a quote.
Thanks for your help!
Sorry! Unable to submit your request at this time. Please try again later.
Report this product